3D printed Shore Trooper

Robiwon

Master Member
Gone but not forgotten.
A friend of mine at work is making this on his home built 3D printer. Printed at 2 microns, this is two days of print work.
 

Attachments

  • 0626170856.jpg
    0626170856.jpg
    1.2 MB · Views: 152
That is approximately 8 million times better than my printer would ever do. Very nice. If he wouldn't mind sharing his printer build that would be awesome.
 
I'll ask him tomorrow. He's doing the full armor also. He gave this to me today too. Very cool. A little clean up and I'll add lights and a switch.
 

Attachments

  • 0627171909a.jpg
    0627171909a.jpg
    1.4 MB · Views: 95
  • 0627171909b.jpg
    0627171909b.jpg
    1.1 MB · Views: 77
  • 0627171910a.jpg
    0627171910a.jpg
    1 MB · Views: 65
Ok, it probably was 200, I don't know that much about 3D printing, lol.
The Thermal Detonator is Uber cool. I'll post pics as I work on it!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top