Making tape glue marks

CARBr6

New Member
So my masking tape has left glue marks in the paint. How do I remove this? Or am I better off just masking off the metal parts and respraying?
 
Is it actually under a layer of paint or on the surface ?
Depending on what paint you used, a Q-tip moistened with rubbing alcohol, should take it off. Wait until the paint is dry.
Go easy on the alcohol and be gentle.
 
Glue marks 'on' the paint can be removed with a light solvent, but most solvents can burn/blush the paint. If it's in the paint, you'll have to wipe with solvent and start again.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top