Target Salt & Peper Mills

division 6

Master Member
I've seen several mentions of Target Salt shakers used as Replacements for Graflex bottoms but have never see one at the store I work at.
However I saw this while walking in the housewares section this morning.
Salt and Pepper Mills.
saltmill.jpg
Perhaps the more knowledgeable will be able to tell if this will work.

It was located in the kitchen gadgets section.
DPCI # 070-05-4607 to identify it (or have an employee with a device locate it for you)
 
It was Bed, Bath and Beyond that made the ones magically the right size. Unsure about these...
 
And I was starting to think that with all the nostalgia feelings in the "Remember when" thread, someone just wanted to build one "old school RPF" for a change :lol.
 
Nothing magic about the size. Stainless steel handicap supports on bathroom walls are the same diameter, thickness and finish is very close. The building I work in has SS hand rails on the stairs. Today I noticed the ends have a flat insert caps.
 
Last edited:
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top