Studio Scale Sandcrawler (ANH)

Incredible build, amazing work so far!. Very sharp & clean work.
I remember my Dad, who is a machinist, he did these for Eric's build & they were difficult to do, but they turned out amazing & Eric was happy, so all good.
I recall they may have been a heatsink originally, who knows haha.

Stu
 
Yeah people did think it was a heatsink but no-one has been able to ID the right ones. So I'll do the same and have them machined in aluminium. Erik's look great so your Dad certainly knows his stuff!
 
Last edited:
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top