Avatar Wasp Pistol UPDATED 7-20 good stuff!

Re: Avatar Wasp Pistol UPDATED 6/4

There was a Japanese model kit (for a different gun, not Avatar) built on a gas powered Tanaka M29 airsoft that included instructions for modifying the revolver to function as a break-two design, the key being that the Tanaka held the gas reservoir in the cylinder rather than the grip. Hypothetically speaking you could apply the same design priniciples to this and I think it would be possible to build an "idealized" version of the gun with the proper action as intended by the design, but never actually achieved on the prop. Could be an interesting discussion.

Regardless, I agree that the 'Wesson' version looks better and cleaner than the 'Ruger' version of the prop.
 
Re: Avatar Wasp Pistol UPDATED 6/11

moving along. light will work. ....moving along......moving along
 

Attachments

  • IMG_2817.JPG
    IMG_2817.JPG
    1.8 MB · Views: 131
  • IMG_2818.JPG
    IMG_2818.JPG
    2 MB · Views: 115
  • IMG_2819.JPG
    IMG_2819.JPG
    1.8 MB · Views: 100
  • IMG_2820.JPG
    IMG_2820.JPG
    1.6 MB · Views: 110
Re: Avatar Wasp Pistol UPDATED 6/11

Thanks Guys! learning a ton working in metal!! 2 things right off...metal gets HOT!!!! and files are your friends!!!:lol
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top