Kryptonite

T

Tomscott

New Member
Kryptonite from superman returns
 

Attachments

  • IMG_1913.JPG
    IMG_1913.JPG
    1.6 MB · Views: 120
Translucent green PETG from Real Filament. I already printed some blade segments with it, but these are just "calibration prints" that I did when I had bed adhesion issues with the new filament. I'm going to use this for the Kryptonite in my Alex Danvers costume. The 3D models are not related to costuming. I figured I would post, because the color match is amazingly close to your photo IMHO. It obviously looks a lot lighter if printed thinner.

REAL_PETG.jpeg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

NuadaDesigns
CWs Arrow- Kryptonite and Trick Arrows
Replies
7
Views
1,220
NuadaDesigns
NuadaDesigns
Simpson77
Kryptonite!!!!!!!!!!!!!!!!!!!!!!!
Replies
9
Views
2,115
Simpson77
Simpson77
supgreg
Kryptonite necklace and trunk!
Replies
7
Views
2,158
supgreg
supgreg
supgreg
Superman III "Synthetic" Kryptonite Replica
Replies
2
Views
2,744
supgreg
supgreg
Jake Kassnoff
How to Make Kryptonite
Replies
5
Views
2,312
Murdoch
Murdoch
Back
Top