3D printed E-11 blaster...

Unfated said:
Thank you. Lots of sanding and filling. The one drawback is 3D printed items are brittle AF so can only really be used for display.
Click to expand...

If you want to make it stronger you can coat it.
If printed in ABS then an ACETONE solution is good
If printed in PLA then VARNISH REMOVER is good

Both will improve the finish - although it is excellent already.

Just my '2 pennies worth'
 
Hi, good job, I just finished my print and got it weathered, decided to go with brass instead of silver to give it a different look.
Also the same guy released a newer version of the print files on myminifactory
https://www.myminifactory.com/objec...ch-e-11-blaster-rifle-by-blaster-master-72283,
DSC_0012 (2).JPGView attachment DSC_0014.JPGView attachment DSC_0017.JPG
they print a lot easier and are more accurate and workable
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

JiminSTLouis
3D Printed Naboo Short Barrel Blaster
Replies
3
Views
621
JiminSTLouis
JiminSTLouis
Hirohawa
How to take apart Master Replicas E-11 Stormtrooper Blaster?
Replies
1
Views
597
Treadwell
Treadwell
Raaven1990
How durable is a DIY Vader saber with 3D printed parts?
Replies
15
Views
610
SPY007
S
AirMech74
My first DIY-3D printed Lightsaber...Baylan Skoll
Replies
3
Views
975
Ghostsoldier
Ghostsoldier
Scarecrow Joe
My Mandalorian Blaster (3D printed)
Replies
8
Views
1,263
baron von blondle
baron von blondle
Back
Top