My Wall-E Build Log

imagine how much faster and easier it would be if you had a laser cutter at home too. Hmm they have a big one at the uni in the mech engineering dept.
 
Well tig welding is quite a challenge I believe. Do they have any of these tools at the maker space in Christchurch? I’ve never been but it sounds interesting. I have a few things I might like to 3D print someday.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top