Part sourcing question

LoneWanderer

Well-Known Member
Hey all, I am trying to find a website where I might locate and source a bunch of dial needles for my pip-boy build. Where would I find something similar to the needle used in the picture included here for the rad counter? Something that is capable of movement would be great! Thanks ahead of time for any responses!

Fo4_Pip-Boy_Mark_IV_system_specs.png
 
Looks like an analogue watch would work. You could take it apart and rig it up inside to a servo or similar to move a small armature. Any pound shop or dollar store would have a cheapy watch that should work.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top