Unique Predator Bio Helmet

PredatrHuntr

Master Member
This is my first Predator mask that is a completely unique design. With inspiration from Robby Clark's drawings, it took me over 3 years to get this from clay to a resin casting. It's made from Smooth-Cast Onyx Slow and measures 20*11 inches.

Normally people will draw their design first and then turn it into a sculpt. With this one, I just made it all up as I went along to make it as unique as possible. I've done my own kit-bashing by pushing bits into the clay - things like a P2 disk in the cheek, tank treads and various other tank parts, Millennium Falcon parts, a Lego light saber, parts from a pen, a mini-clothespin, guitar wire and a muffler from my son's broken toy motorbike.

0%202.jpg



0%203.jpg


0%204.jpg


0%205.jpg


0%206.jpg


0%208.jpg



0%2012.jpg


0%2014.jpg


0%2016.jpg


0%2017.jpg


0%2018.jpg


0%2019.jpg


2207.jpg


2206.jpg


4%202.jpg
 
Last edited by a moderator:
Very nice. I've been looking for a cast of the original bio helmet shape to paint. There used to be loads around but they seem to have dropped off in popularity
 
Wow just waow!
the amount of details in this.... absolute masterpiece !
Shane black should had contacted you !!

- - - Updated - - -

it remind me kind part of Fallout , kind part of Darth Vader , it is awesome !!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top