Original Colonial Viper helmet

WP_20161222_002.jpgWP_20161222_001.jpg I've been working on the rim around the neck. Also laser cut the front indents. When I built it I stuck a block wood in the top for support so I cant put the helmet on yet. Doh!
 
Very nicely done. The symmetry looks spot on and I know that isn't easy. I guess a person could 3-d print the whole thing but where is the fun in that. Well done
 
The helmet has been moulded and had several casts now. I'm very pleased. Excellent detail. DSC_0002[1].JPG
I bought some cheap knee pads for padding. They are made of a light weight foam and are easy to bend into the right angles. Once fitted they look like they were made for the helmet.Padding 4.JPG
 
If you have a design for the crest i can print it for you,plus i'm in southeast london so getting it too you would be easy
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top