Temporary Kylo Ren light saber changes

Capn_Jack_Savvy

Sr Member
I am looking for a way to add silicone to my KR saber blade without actually placing it directly onto the Disney FX blade. It is just too expensive a product to do that so.......

I purchased the florescent plastic light tubes but they are 1 1/2 inches while the saber blade is about 1-1/18 inch wide. I figure I could cut it down to size and wrap it around the blade creating a sleeve but securing it to the base of the saber is the tricky part.

Anyone else out there do something like this?
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top