Black Panther Helmet WIP

Thread starter Lord Magneto
Start date Aug 26, 2016

Lord Magneto

Sr Member

Aug 26, 2016

Here is a first look at the helmet. I will post some more progress pics later tonight.

I'm currently going back over it and trying to smooth out areas and working on a hinge to connect the pieces so I can easily take it on and off.

I'm debating on sealing it all up completely and then recutting the back out to make the process of taking it on and off easier that having 3 pieces.

3D Printed using my bq witbox printer and black PLA.

Here are some photos

Last edited by a moderator: Nov 8, 2018

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.