BTTF2 2015 Jacket

GBRob

Active Member
Just an experiment for the latex sleeves. The shoulder bellows will be a different mold.

13669784_10209870414182969_2916082134908684982_n.jpg


13680902_10209870414262971_7103536927077474618_n.jpg


13606897_10209821390157399_4149546669800184215_n.jpg
 
Yeah the red material (latex) was a test pull from the office light diffuser you guys talked about on the other thread.

Going to re-do the arm mold in separate parts. 2 bellows (elbow and shoulder), then will cut the sections of the arms to attach to the bellows. See how it goes.
 
Amazon. The Diamond select hat. Looking to make an accurate hat as well as they have the lenticular sheet on Amazon.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top