Darth vader Gary Kurtz

redbutton

redbutton

Sr Member
RPF PREMIUM MEMBER
Hi everyone, I'm going be building a Gary Kutz darth vader saber! This was an accidental find cause I wanted the graflex clamp that was
attached to it. Anybody have any idea about parts. I know there's a graflex slave that I need to find. What about the clamp and the lte on to of the saber
near the emitter. Any help would be appreciated!
 

Attachments

  • image.jpeg
    image.jpeg
    1 MB · Views: 104
  • image.jpeg
    image.jpeg
    1.3 MB · Views: 76
  • image.jpeg
    image.jpeg
    986.8 KB · Views: 91
I'm excited for this! Either NeoRutty or Edraven also has one I think...

it was VERY simple to take apart. screws, wiggling and a hacksaw to remove the bracket for the bulb leaves you with this!
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

absulition
Darth Vader Shin&Cod Template
Replies
1
Views
239
lethyry
lethyry
Anakins father
Darth Vader's Rogue One lightsaber
Replies
15
Views
765
Anakins father
Anakins father
Skywalker1973
Darth Vader ESB armor 501st eligibility
Replies
11
Views
1,195
Skywalker1973
Skywalker1973
mosseraiser
Gary Kurtz Graflex lightsaber making process
Replies
14
Views
1,619
Mottrex
Mottrex
blewis17
PICS Lager Toys Darth Vader Helmet
Replies
4
Views
1,055
CHSimp94
CHSimp94
Back
Top