Ghostsoldier's WIP of Vader's grandson, Ben Solo (#budgetKylo)

Thread starter Ghostsoldier
Start date Feb 15, 2016

Ghostsoldier

Sr Member

Feb 15, 2016

I'm learning a lot here on the forums from you guys, and it's much appreciated. Since everyone has to start somewhere, here's my budget take on Kylo's belt buckle; I used 3mm Sintra and styrene, coated with primer and then a hammered finish. I may make another later, but this is my first attempt.

For those interested, I created an AutoCad drawing of the buckle, based on the Celebration display belt photos; here's a link to the 8.5"x11" PDF of the drawing: http://www.mediafire.com/view/n64ru62g7r8scea/Belt_buckle_1.pdf

More to come later, as I learn my way through this awesome costume.

Rob

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.