Sym-Cha
Master Member
Re: Military Graflite "Stealth" Saber build
So certain are you? Did you do some proper measurements? Well okay I did them for you ... the inner space in your MPP 2 step shroud (yes I have the part too) is about 9.5 mm wide whereas, if you want to use the screw in the the rounded fin part and swap it for the black painted screw in your graflite, that's already 11.5 mm before that screw so it won't fit properly, however the first part veektohr offered will fit perfectly screw and all in the screw hole near the shroud, which may need to move up a bit, being only 8.5 mm at the widest and would resemble the part on the real MPP a lot closer eventhough it's way shorter
So please, Panaflex, do some measurements on your shroud before commiting to fine looking greeblie parts just based on pictures alone ... that said I think it's mighty gracious of veektohr to offer both parts so generously
Chaim
Yep! That's the little bugger!
So certain are you? Did you do some proper measurements? Well okay I did them for you ... the inner space in your MPP 2 step shroud (yes I have the part too) is about 9.5 mm wide whereas, if you want to use the screw in the the rounded fin part and swap it for the black painted screw in your graflite, that's already 11.5 mm before that screw so it won't fit properly, however the first part veektohr offered will fit perfectly screw and all in the screw hole near the shroud, which may need to move up a bit, being only 8.5 mm at the widest and would resemble the part on the real MPP a lot closer eventhough it's way shorter
So please, Panaflex, do some measurements on your shroud before commiting to fine looking greeblie parts just based on pictures alone ... that said I think it's mighty gracious of veektohr to offer both parts so generously
Chaim