DeAgostini Millennium Falcon by dtssyst

The parts turned out a lot better than I thought.
Our two sets for our personal kits and dlbsyst set is ready for him (free of course).
dlbsyst parts are shown in the attached image.

Note: two parts are not shown. One is cast and turned out ok. The other I can not do.
Not a deal breaker. I'll scratch it or other means as I do not want to ruin the kit.
 

Attachments

  • 20170201_171113.jpg
    20170201_171113.jpg
    2.7 MB · Views: 409
Hey Antonio, that sounds good, pieces for everyone via shapeways. You have here good references for search the kits.
Greetings, Kuat.
 
1. See first post,
Parts Missing on the De Agostini Millennium Falcon,
(photo) Tamiya 1/35 Panzerspahwagen 8 Rad SdKfz 232

2. Tamiya 1/700 British Hood & E Class Destroyer Part 51
The photo you show is not showing the correct part.

Gentlemen, i have two questions:
1. where on the Falcon go this part:
[URL]https://c1.staticflickr.com/3/2110/32782527166_10df36f89c_c.jpg

2. Do anybody know this part ID ?
[URL]https://c1.staticflickr.com/3/2633/32669777852_c3385d83b2_c.jpg
 
Last edited:
It is on the DeAgostini side wall, just not exactly in the correct location. Unless you know of another location that it is missing.

Issue 95, page 9, step 07
Part (5) is glued to SP-14 a little to low.


2. Tamiya 1/700 Hood - A51
 
Last edited:
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top