Reverse Flash Ring

Thread starter Bogleo
Start date Nov 24, 2015
Tags

the flash

Bogleo

Well-Known Member

Nov 24, 2015

I just finished season one of the CW Flash show, so I wanted to make the Reverse Flash's ring. I modeled it in Blender:

I printed one in trans yellow PLA, but it was too big, and the print quality was meh. :unsure I'll get some pics of it up once I get home. Will be re-printing it soon, and then I may get one in polished or gold plated brass from Shapeways.

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.