Superman DOJ suit completed

Tribal

Active Member
Heya all,
Stared on the new superman suit a bit ago and decided to make it from scratch , the logo i made in blender and zbrush to later let it be 3d printed and make a mold from it so i can cast them in latex :), the rest of the trims are made freehand from the pictures i found online, also made molds and are in latex.

grtz.

12171123_10206774654738635_406704564_o.jpg
12287179_10206949921760201_332545664_o.jpg
12270156_10206946748560873_77812808_n.jpg
12270469_10206944520745179_966849906_n.jpg
12268922_10206941358586127_659292894_o.jpg
12271385_10206944522145214_54225469_o.jpg
12272715_10206925987641863_639480398_n.jpg
12242121_10206926337170601_1335871571_n.jpg
 
Last edited:
Re: Superman DOJ logo and trims

Thanks for answering! I appreciate it! Would you think something like this would suffice for a bodysuit? Says its lycra and I can have it custom fitted.http://m.zentai-zentai.com/navy-ful...ex-lycra-unisex-zentai-suit-products-283.html
Also did you use black puff paint?
Awesome stuff can't wait to see your finished build

That looks ok but it wil be hard to draw the texture on it with the puff paint , its easyer when you draw it all on there first and then sew it all up
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top