Fine Molds 1:144 Millennium Falcon - Force Awakens Edition

DanielB

Sr Member
Used 3D printed parts on the cockpit cone and radar dish to turn the Fine Molds Millennium Falcon into it's Force Awakens counterpart. At least until the Bandai Version gets here.


7QeF06z.jpg

Sk6GGxi.jpg

5jI8hn0.jpg

4sQQ0Fd.jpg

sHQT53R.jpg

q3XbYGq.jpg
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top