Mad Max: Fury Road Skull Shift Knob (Mediocre)

Brockwall56

New Member
My test version of Immortan Joe's skull shift knob. Sculpted out of air dry modeling clay and painted with acrylic paint. Not the best sculpt job, but for a test it turned out okay.

I want to be able to make a mold of this but I don't know if it would be possible. Any suggestions of how i might be able to make a mold?

Fury Road 1.jpgFury Road 2.jpgFury Road 3.jpgIMG_0041.jpg
 
Last edited:
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top