Next job was to get some new gun covers made.
I opted to go for laser cut ones as some of the corners are pretty tight.
Once they were done I sliced the front in two so I could trap the mesh between the layers.
Very good work. I am doing something very similar to what you have done in that I am cutting open my gun doors as well to replace them with new parts. My edge strip is a little bit thinner than yours, I tried to match the 1:1 car on that detail, even though it doesn't really matter.
I'm hoping somebody makes a perfect 3D printed set of engine grilles, that'll encourage me to get into my build again.
Would you be willing to make an extra set of laser cut gun doors? I think those look great! I'd love to add them to my build.
There's a chap 5 mins up the road from me. He's been a great help with quite a few things model related.
I'll see if he wants to be known, then let you know.