89 Keaton Batmobile

Next on the to-do list was some parts of the side detail bits.
I tried to 3d print these but they came out shockingly bad ,





So I decided to build them myself,

 
looks like the PLA used for printing wasn't hot enough, try increasing the temp by 5 degrees and see if that helps, amazing work btw.
 
A full interior would be so difficult to get right. I think I will tint my windshield, plus I don't want to chop my canopy up because it's a 1st gen production made casting.

Truth be told I don't think I'll ever finish it. How is yours going?
 
Well now I've got myself and SLA resin printer I've managed to get all of the side mechanics done by fiddling around with files, resizing and chopping them up this is what I was looking for,
IMG_20190803_122344.jpg

. and this is what I have now

IMG_20190803_122549.jpg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top