Arkham Knight Red Hood

Sorry I have hardly had time to get on here for a while. Many things have been keeping me busy. So I have made the whole suite and armor. This means the helmet the guns and the spat(shin guards) as well as the magazines that fit on the side. Here are pics of the finished work. And yes the helmet is see through.

12647219_10156423304845034_1052290380992240083_n.jpg


12052459_1072975146047646_3316419680787581343_o.jpg


11930957_1072975046047656_7514202822180354017_o.jpg


12043059_1072974769381017_259867987004808385_n.jpg
 
An incredible about of detail here. Stupendous work! One thing, though...aren't the bullets facing the wrong way in your magazines you have attached to your thighs? I haven't looked at the game model that closely, but they look like they should be facing down for a quick reload.
So, how did you get the helmet to be see through for the wearer? Purely curiosity, here.
 
An incredible about of detail here. Stupendous work! One thing, though...aren't the bullets facing the wrong way in your magazines you have attached to your thighs? I haven't looked at the game model that closely, but they look like they should be facing down for a quick reload.
So, how did you get the helmet to be see through for the wearer? Purely curiosity, here.

The helmet was tinted then I used the same things that the halo visor guys do. Just Google that to understand how to do it. Would take a while to explain. The bullets are as the game model shows so one would have to argue with the designerror lol but I agree with you.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top