Radioman
Active Member
Here's my submission in the "post your 3D printed Kylo Ren lightsaber hilt" competition. 
This is, of course, using the file that's been floating around.
What's different with mine, is that I didn't like the way the end cap looked. This is based on the prop that was shown at the Star Wars Celebration and no one could see the bottom. So I designed and printed an end cap that I thought was representative of the overall style. I think it looks much more complete even though it's not technically canon.
Painting was basically a process of Flat Black, dusting of metallic silver, detail paint, and then a two part process of oxidizing metal paint. What looks like rust on this piece is ACTUAL rust.
Here's the pic from Celebration for reference.
Enjoy!
Mark
This is, of course, using the file that's been floating around.
What's different with mine, is that I didn't like the way the end cap looked. This is based on the prop that was shown at the Star Wars Celebration and no one could see the bottom. So I designed and printed an end cap that I thought was representative of the overall style. I think it looks much more complete even though it's not technically canon.
Painting was basically a process of Flat Black, dusting of metallic silver, detail paint, and then a two part process of oxidizing metal paint. What looks like rust on this piece is ACTUAL rust.
Here's the pic from Celebration for reference.
Enjoy!
Mark
