Kylo Ren Helmet Foam Build WIP

Thread starter Gunslingerzero
Start date May 21, 2015

Gunslingerzero

New Member

May 21, 2015

So I decided to try my hand at building the Kylo Ren helmet using foam and a pepakura file made by Rundown. I have the full helmet built, I still need to seal it and sand down some rough spots and then prime and paint it. I didn't change the scale of the file so this first helmet is huge, especially for me (only 5'8") so I'm gonna scale it down 20% and reprint it. I plan to finish this one too though and probably sell it.

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.