JJ Griffin
Sr Member
Getting this bad boy modeled. Will print it off our Taz 4, clean it, beat the tar out of it, and mold it for casting (either cold cast or resin). The infamous "red wire" will not be apart of the mold but attached afterwards. This will be hollow to allow for the insertion of electronics and saber blades. Here's what was most likely the rubber "stunt" saber on display at C7:
View attachment 16591035584_4d46eec00b_o.jpg
Here's our progress thus far:
Thanks for reading
View attachment 16591035584_4d46eec00b_o.jpg
Here's our progress thus far:
Thanks for reading