TFA Graflex Research (That's a Graflex, right? Force Awakens teaser trailer #2)

I can see threads!
fc8ad3c9914a5303e5c4f21d782bca63.jpg
 
Also I don't think I've ever seen a washer that would have an inside diameter that large and an outside diameter so small in comparison. They would have had to modify a washer to fit under there or make their own custom one, neither makes any sense for this prop at all.

I also have to say that if a prop department could make a Graflex replica from scratch with such accuracy as to best the efforts of those who make them here (think about the time and effort they put into them, even the guy making the stainless steel one) they would be the best prop department ever! They would never take the hours and hours to make one when they could pop online and buy any number of very accurate replicas by the dozens.


Sent from my iPhone using Tapatalk
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top