V4 1:1 Scale YODA Sculpt

Indeed the neck looks a lot better ... as I suggested many moons ago :) ... I'll probably need to sell some of my leftover G R A F L E X flashguns after Episode VII to be able to fund a full and functioning puppet, just need to be able to muppet his mouth perhaps eyes/ears rather simply with my hand and fingers inside ... :wacko

Chaim
 
The Neck circumference is actually larger than the V3 - its the rest of it thats so much bigger that makes the neck look thinner lol... But all the geometry matches perfectly to the screen pull.

11174793_10206547712277101_6195786384384130731_n.jpg


11150512_10206547712597109_6115459509639997872_n.jpg
 
Put some wires in this and a set of rough handpainted eyes to gage to scale etc.... Its possible to add a lot of expression into this version.
 
Last edited:
WONDERFUL!

So you added the wires ex post (your V3 had the wire armature cast in)? Was it hard to do/ what modifications did it take?
Now post some pictures of your other revised V4 parts (hands, torso etc.), we are KEEN on seeing the updates ;) !

Markus
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top