I still need to pop off the beer can tab (any advice?
Yes, DON'T DO IT!
Kill a replica, not an ORIGINAL GRAFLEX!!!
You're breaking my heart.:cry
Wait til I have half a dozen holes drilled into it
This will eventually be used for my vintage Graflex Vader ROTJ stunt saber build.
I honestly have yet to successfully flatten the bunny ears tabs. On a Larbel the metal started to split like bread dough, and on a graflex slave I destroyed the bunny ear pin, and then couldn't get them to go past like 30 degrees :lol
Not inspiring lol...
Hahaha
What I used were big strong needle nose pliers or flat pliers with a pointy tip (you need thin ones to get the angle) and slowly bent them in. after a while I couldnt figure out a way to get in there without turning it upside down and pressing them on the table, if that helps
Not inspiring lol...
grab that sucker with pliers and twist. it'll snap off.