Important Question: Casting Plaster

NSStudios

NSStudios

Well-Known Member
RPF PREMIUM MEMBER
I have some 74-30 rubber molds and I was wondering if I could cast plaster in them to make master copies of the pieces? Is this a possibility or could it damage the molds? Keep in mind I have Mold release. A quick reply would help me tons! Thank you!
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

propmaster2000
For those with a 3D Printer looking for something to print. :) "THE MOST IMPORTANT DEVICE"
Replies
12
Views
1,536
mrwax
mrwax
BonesAreDollars
Question about casting
Replies
4
Views
834
BonesAreDollars
BonesAreDollars
princemercury1
Weathering a prop piece question
Replies
10
Views
588
princemercury1
princemercury1
greenmachines
Crossing streams - on purpose, parts question for UK rpf members
Replies
4
Views
276
VanPersie
VanPersie
Imagehunter
Graphite powder question
Replies
6
Views
1,181
minieffects
M
Back
Top