Goonies copper bones

Htofstead

Well-Known Member
So I had some free time and although not 100% accurate I dexird to make a Goonies Copperbones key. It's good enough for me since this will be displayed on my wall. Need to go back and add some more paint to give it more of a "copper" look than a gold look. Made from sculpey clay then baked in my oven
 

Attachments

  • image.jpg
    image.jpg
    623.3 KB · Views: 76
  • image.jpg
    image.jpg
    871.8 KB · Views: 70
  • image.jpg
    image.jpg
    735.6 KB · Views: 66
  • image.jpg
    image.jpg
    792.3 KB · Views: 59
  • image.jpg
    image.jpg
    886.5 KB · Views: 60
  • image.jpg
    image.jpg
    1.1 MB · Views: 68
  • image.jpg
    image.jpg
    1.3 MB · Views: 61
  • image.jpg
    image.jpg
    1.8 MB · Views: 68
I would say job well done. It looks great. How did you get the copper/gold look? I'm working with the same kind of foam right now and any tips are welcome

-R-
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top