Merry New Year,
Welcome everyone to 2015, I hope everybody had a fun and safe Christmas and New Years holiday and I wish you all the best for the coming year.
Thanks for the comments guys, much appreciated.
Yes Wibble i have seen them but thanks for the thought
Is that a Multistrada over by the monitor?
No, It's a Hypermotard 1098S, my bike of choice, my wife just got a Monster 796.
So too business,
Well, I only had two days of bench time over the holidays because my Mommy was visiting.
First, I cut the central pipe/bearing shaft and drilled holes in the outer panels of the engine support arms, this was so I could re-align and square up a bit, the side support arms. I will clean the pipe end flush later.
I then cut and glued a piece of 1/8" styrene to the bottom of the engine support arm,
1.0mm on the top, oversized so it could be trimmed back,
Trimmed,
Replaced the underside of the neck piece with 1mm styrene,
Screwed in place,
With engine support arms,
More filling and sanding and filling and sanding........
Then, dum dum daaaaa,............Primer
Mmmmmmmmmmmmmmmmmmmmmm Primer
That's all for now
Take care
Gag