Iron Man: Bleeding Edge w/3d files

Looks like it's the right size. Gonna figure out the scale factor tomorrow when I have more time. uploadfromtaptalk1414911766949.jpg
 
At Disneyland for the week. I'll be back to work after my vacation. Sorry but Disneyland takes priority. .. especially when I just got engaged to my girlfriend. :)
 
Increase scale 7,489.06% ... thst should bring it closer to the actual size. It may still need some additional scaling but that gets us in the ballpark.
 
Just compared the scale I made with Dunbean's Mk4 helmet and aside from larger eyes, the size it pretty darn close.

Untitled.png
 
Just added the neck to the first post. It should be scaled but until it actually gets built, its hard to say if the scale works.
 
The parts I posted are not meant for 3D Printing... unless you can mod them to have some depth. Otherwise they are only ready to print on paper. Once i know the helmet is good for sizing, I'll post those parts on the forum for people to download the stl's
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top