Re: NeoRutty's Prop Projects - Call out! Anyone with machining skills to solve a pro
hmmmm a hole through the other side may not be bad... if I COULD fill it cleanly after...
It's an option.
Still really hoping Anakin Starkiller has another... just do it over... The first one we did went so easily. It's crazy this is even an issue.
I'd go for a slightly smaller drill piece, is there any way you can sink the drill piece deeper in the chuck that way you'll have less flex on the drill bit itself which might help?
Alternatively how about starting off dot punch it and use an archenemies drill which is nice and small hand held, will be a bit painful (slow) but might just get you a starting point to be able to use a larger drill?
Another alternative which I don't think you'd want to go down the route of would be to drill from the other side 180 degrees with correct drill (all the way through), then plug the old hole from the other side with an aluminium rod, you could turn that down in place to give you the correct curve, I've seen that done before and looks okay - as to say difficult to note.
hmmmm a hole through the other side may not be bad... if I COULD fill it cleanly after...
It's an option.
Still really hoping Anakin Starkiller has another... just do it over... The first one we did went so easily. It's crazy this is even an issue.