Star-Lord Mask Help

DonnyTheBear

New Member
First off I'd like to say I'm new to this whole 3D printing thing so please excuse my ignorance. Anyways, I've been making this Star-Lord costume/cosplay for Halloween and I go to a school where they have a 3D printer. The printer I believe is a Makerbot Replicator, my teacher said if I brought the materials for the mask I could print it out, I was wondering what file is compatible with a Makerbot. I know how many wonderful Star-Lord Pepakura files there are but I'm just not sure if they're compatible. Sorry for being vague on the Makerbot, I've completely forgot which specific version it is.
 
The .STL files found in Helagak's thread will work with just about any conceivable 3D printer, just read his instructions on scaling. Plain Pepakura files cannot be 3D printed.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top