My PVC, Sintra and Cushman DC-15

WhiteCommando

Well-Known Member
Hey guys, I made a DC-15 out of 1.5" diameter PVC pipe, some couplings, some Sintra (some very thick.), Sculpy Plasticine Clay, wood dowels, and a Cushman MG-34 receiver Paintball Marker cover.

Some paint, glue and a little bit of time. Please view pics...

DC15CloneBlaster.jpg


DC15receiverstock.jpg


MyDCFinal.jpg


An in-progress shot...

DC15SideFront.jpg


Lots of fun.

Later,

John
 
I can make a tutorial. First off, get some 1.5" inch PVC, a 1.5" coupling, two 3' foot pieces of 3/8"x3/8" inch wooden dowel, and make 2 segments of pipe...one is 13" inches and another 15" inches. Couple together. The short length is the front barrel. Cut the dowel to 12" inch strips (6 total) and glue with CA gel 3 per side.

More to come later.

John
 
Looks great WC. I need to make one of these bad boys.
If you got anymore in progress shots by all means post'em;-)
-Goldenrod
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top