Help with deathstroke armor .obj file! (First post)

Thread starter 1337falc0
Start date Jun 2, 2014
Tags

deathstroke

1337falc0

New Member

Jun 2, 2014

Hi all! I'm new to the forums so I'm not sure what section to post in so I posted in this one.

Now onto my problem. I have recently acquired a .obj file for the character model for deathstroke's appearance in Arkham origins. Problem is that the full body model is still attached to the armor, which I really need for the costume I'm working on. I don't want to have to waste paper printing out the whole body in pepakura just to cut out only the armor parts. Is there any way I can remove the body from the armor? Or could someone do it for me? Thanks in advance

Also, i will probably upload the file later today.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.