Iron man faceplate

IMIM2

Sr Member
I wanted to create the faceplate with the inner details.
I am using Sharkhead's pepakura as template (and thank you).
Also special thanks for Zendragon for his amazing work on the inner detail.

The base is made from 6mm foam.
I am using toilet paper to wrap on the outside and hardened it with resin.
This is the first time I tried it, and it turned out very nice.
After that, I used filler, and sanding it but not too smooth.
I want to have some "raw" finished.
This is my second time using filler, so I didn't do a very good job either.

I ended up with a bit titanium look, and still not happy with it.
So I did a bit silver highlights on the edges.
Since it was supposed to be gold-titanium alloy, I was tempted to use gold highlights.

Using 2mm foam, I added the details.
Paint it all black and start painting it with brush.

This is not finished yet, I still have 4 parts and eye lenses to add.
I am trying to figure out on the display stand too.

Enjoy.
 

Attachments

  • faceplate1.jpg
    faceplate1.jpg
    140.8 KB · Views: 168
  • faceplate2.jpg
    faceplate2.jpg
    146.4 KB · Views: 241
  • faceplate3.jpg
    faceplate3.jpg
    171.3 KB · Views: 181
  • faceplate4.jpg
    faceplate4.jpg
    307.8 KB · Views: 209
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top