1/32 Viper MKii OOB build & mask dev

Orbital Drydock

Active Member
Here’s my Moebius MKii Viper build & mask dev. This is the new clean ghost Kara Viper. Complete with corrected tail numbers & all. There are still a few touch ups & decals to be done, but she’s mostly there.
All striping & the tail numbers are painted using my new mask set. It has masks for all of the stripes, canopy & alt tail number masks for 8757NC, & N742C along with replacements for the decal tail numbers. This set is also all kabuki tape.
Enjoy the pics!

DSCN0274_zpsc74b353e.jpg


DSCN0277_zps62f4eed2.jpg


DSCN0279_zps4a071573.jpg


DSCN0285_zps460a5cca.jpg


DSCN0286_zps986d3600.jpg


DSCN0287_zps4a74d87c.jpg


DSCN0320_zps46cb1b8c.jpg


DSCN0322_zps59fd3cfb.jpg


DSCN0357_zpsab0b0dda.jpg


DSCN0358_zpsf2934961.jpg


DSCN0359_zpsfc4f0184.jpg




DSCN0361_zps55d80322.jpg
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top