District 9 assault rifle help needed

xenochimp

Active Member
Hi Guys and gals,

I was hoping one of you lovely people may be able to help. I am planning on embarking on a 1:1 replica of the D9 assault rifle. I have collected some really good clear images and some measurements of the prop and the Weta replica but I have a few areas I can't get clear images of and am struggling with lots of measurements. I was hoping someone here who was lucky enough to snag one of the replicas could help me out. If you can could you PM me or e-mail me at ptindall@aub.ac.uk

Any help would be a big help.

Thanks

Pete
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top