My ABC warrior head ( Judge Dredd )

buckettt

Well-Known Member
I see alot of abc robot heads being constructed on here (but never finished)...so I decided to make one over the course of a few lunch breaks.....( not extremely accurate, just a fun little project) .... head was carved from a block of foam w/ brow details shaped from some paper mache clay....and lower jaw made from foam poster board...along with some pvc for the neck pistons..thanks for looking


22380-dsci1176.jpg



22381-dsci1179.jpg
 
eyes were made w/ some led bulbs (functional/ lights up) and detailed with a couple different types of washers I picked up from hardware store.....sorry for the lack of "progress build pics ".....this was just one of those side projects that came together quickly and I never thought to take pics of.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top