INT: Dredd 3d belt buckle cast of screen used UPDATE

Did all the screen used belts have the dent on the left side wing as you are facing it?

Most of the screen used ones I've seen all have that chip in the corner and the dent and little other artifacts in the casting. I could take a casting and fix it up perfect but then it wouldn't be the same.
 
Hi Max, I actually made 2 today, they were all done, I clamped them to the belt and the clamps dented them which means the resin went bad. Im going to get more resin and powder tomorrow so I can make a few more.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top