USS Constellation NCC-1017 COMPLEATED

trekman1017

Well-Known Member
I had been working on this model on and off since 2009, most of the construction pictures can be seen on this thread: http://www.therpf.com/f10/amt-enterprise-filming-model-104884/
If I built this in 1968 there would have been no modifications, but as I used a small box kit from the late 1980's it was heavily modified. I made a new deflector dish out of a ping-pong ball, I made a new deflector housing, the balls at the end of the nacelle were ground off and the decals were downloaded from Shaw. This was my first attempt at printing decals.
http://i.imgur.com/UjRwL.jpg
http://i.imgur.com/jPPaJ.jpg
http://i.imgur.com/ryXuB.jpg
http://i.imgur.com/PFn40.jpg
http://i.imgur.com/x1ixw.jpg
http://i.imgur.com/xmuEp.jpg
http://i.imgur.com/RTh1W.jpg
http://i.imgur.com/UxaH3.jpg
http://i.imgur.com/3dFiG.jpg
http://i.imgur.com/hE1FA.jpg
http://i.imgur.com/bV8qT.jpg
http://i.imgur.com/LDiFc.jpg
http://i.imgur.com/ZTeS5.jpg
 
It looks great!

Yeah, I'm not quite up to printing out my own decals yet... though I might give it a try if I ever get a good printer. :unsure
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top