Finished: Jedi Training Seeker/Remote

vistaVision

Sr Member
Plastruct hemispheres, detail parts from Adamata’s current run. While his rims were very nicely cast, I didn’t like the look of them simply painted,
and sending them out for plating was going to take too long. So I scavenged the correct rims from a vintage AMT Midnight Express kit.
Might be a bit over weathered, it’s hard to know when to stop!
I had posted a few WIP pictures in KrokoHunter’s build thread, here: http://www.therpf.com/f10/anh-jedi-training-remote-150843/

Many thanks to Frank for his very detailed tutorials on building and painted a seeker.

attachment.php

attachment.php

attachment.php
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top