"Bombs Away" techinque for resin or just silicone?

Thanks!!! So it's not as simple as I thought. :) Up to what PSI does the common compressor put out?... a little pressure is better than no pressure? or should it really be 100psi at least?
 
Locry said:
Thanks!!! So it's not as simple as I thought. :) Up to what PSI does the common compressor put out?... a little pressure is better than no pressure? or should it really be 100psi at least?
Click to expand...

The idea is to crush the bubbles in the liquid resin so that when it has cured, the bubbles can't expand. So you need at least 100PSI.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Real Scooby
Anycubic or Elegoo ?
Replies
17
Views
564
StevenBills
StevenBills
Tremas
The One That Got Away
2
Replies
24
Views
2,207
Tremas
Tremas
SGluedMyFingers
UV resin recommendations/advice?
Replies
2
Views
396
SGluedMyFingers
SGluedMyFingers
O
3D Printers for Modelers?
2
Replies
20
Views
1,191
TazMan2000
TazMan2000
Solo4114
Looking for terrain tips
Replies
7
Views
403
Solo4114
Solo4114
Back
Top