ACC Skyrim Dragon Priest Mask

Sisko4

Active Member
After severall Hours...with Hours i mean Days...in the awesome World of Skyrim, i decided to build the Dragon Priest Mask.

There are several other Masks out there, but not all are smooth and molded/casted.

I worked about 2 Weeks on it, from the Pepakura Stage (Thx to Hugh Holder for the best DP Mask File EVER) to the Molding Stage, Weekends don´t count.
The Mold was made with my favorite Silicone, Rebound 25.
Cast made with Task21.
For the Painting, i used something special and expensive, Granite Texture 3D Paint.

Now i only work on the Padding and adding the Headbands.






[NOTE: The Picture with the Mold in the Mothermold shows a little Space on the right Side, that´s because i don´t layed it correctly in the MM!)
 
Very cool!!!!!!!

Love the rock texture :)

Are you going to make the full set? I only have one so far in my game, but I am hoping that I will be adding a few in a week or so :)

Chris
 
Very cool!!!!!!!

Love the rock texture :)

Are you going to make the full set? I only have one so far in my game, but I am hoping that I will be adding a few in a week or so :)

Chris

Maybe, if the Sprays not making my Bank Account empty^^
the Granite Spray costs about 17USD for a small Can...
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top