Iron Man Mark VI foam build "hybrid" for halloween 2011 Ready!

Hello, after reading an watching a lot of threads I decided to build the Mark VI armor using the cheapest materials possible, the total cost was like 140 for everything you see, including the parts I did not built


For the arm repulsors, I used the repulsor glove toy (14 bucks each on walmart) and for the helmet i unsed the official movie helmet (25 bucks on ebay) and then modified it and reinforced. i used some window hinges from lowes (4 bucks each)


for the eyes and chest y used 3 old solar garden light (3 bucks each at walmart)


for the neck and abs y used foamies and the rest of the suit is white foamboard and paint


I used the foam pepakura templates as a base and then modified to cut the less pieces possible on the foamboard... and of course a lot of hot glue
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top