Molding an Original Ghostbusters® Prop

TK648

Sr Member
I thought a lot of you GB fans may like to see this.

When it came time to reproduce an original Terror Dog from Ghostbusters®, Paul Francis needed a way to make a master copy from the original plaster mold. This copy needed to be easy to remove from the mold, and also needed to be able to be cut up to be remolded. The remolded pieces would then be cast in resin to make a limited edition collector's piece.

Paul chose Mold Max 30 to cast into the multi-piece mold to produce a master copy which could then be easily cut apart. Mold Max 30 is a strong, low-viscosity tin silicone which is very reliable and captures excellent detail. It is also very easy to accurately cut, a crucial factor in this project.

For more information on this project or to pre-order one of these pieces please visit

Molding an Original Ghostbusters® Prop | Mold Making and Casting Materials Rubber, Plastic, Lifecasting, and More
 
The link is an example for an advertisement f the molding product. Does not look like the project is still ongoing. Too bad, I also would love to get one of those replicas as well.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top